The hand loom

Level 31

This walkthrough shows once you unlock the level.

A handloom weaver's corner stands on the table. In the middle is an oak floor loom with four shafts hanging from its top, four treadles at its foot and a cream warp running through it. A brass oil lamp stands on the right end of the loom's top board. Its flame burns brighter with each step you finish. An oak box bench stands at its front right, and a draft card stands on an easel at its front left. A dye bench with five crocks stands at the left of the table, and a bobbin winder with a wheel and a swift stands at the right.

Find the shuttle in the bench, dye the skein the colour of the draft card, wind it onto the shuttle, tighten the warp, mend the broken end at the back of the loom, and weave the draft. The bench, the dye bench and the cloth beam can be worked in any order. The stirring stick in the blue crock, the two sticks across the warp behind the shafts, the shears on the table, the lid of the fleece basket and the wooden niddy-noddy beside the dye bench all move but open nothing.

The bench
  1. Tap the wooden button on the front of the box bench. It turns flat.
  2. Tap the lid. It swings up on its hinges.
  3. Tap the boxwood shuttle on the folded cloth inside. It goes into the satchel.

A tap on the lid while the button stands up only rattles it.

The dye pots

The draft card on the easel shows the cloth in cream and one colour: orange, green or purple. That colour is the colour the skein must take. Tap a crock to dip the skein in it. The rules:

  • The red crock is madder and the yellow crock is weld. They stay on the skein only if the skein has been in the clear crock with white crystals on its rim first. Without it, the colour runs out of the skein as it drains.
  • The dark blue crock is indigo. It stays on any skein. The skein comes out yellow-green and turns blue in the air. The blue crock also takes the clear crock's work out, so red or yellow after it runs out again unless the skein goes back into the clear crock first.
  • Colours mix on the skein: red and yellow give orange, yellow and blue give green, red and blue give purple.
  • The grey crock takes every colour and the clear crock's work out. Use it to start again.

Dip the skein in this order for the card's colour:

  1. For orange, tap the clear crock, then the red crock, then the yellow crock.
  2. For green, tap the clear crock, then the yellow crock, then the blue crock.
  3. For purple, tap the clear crock, then the red crock, then the blue crock.

When the skein has the card's colour it lifts off its hook and goes into the satchel.

The winder

This needs the shuttle from the bench and the dyed skein from the dye pots.

  1. Tap the empty swift of crossed slats with the dyed skein. The skein opens round it.
  2. Tap the bare steel spindle at the front of the winder with the shuttle. The shuttle's pirn goes onto the spindle and the shuttle lies in the tray.
  3. Turn the crank on the wheel three times, or tap it three times. The swift turns and the yarn winds onto the pirn until it is full.
  4. Tap the full pirn. It drops into the shuttle, and the wound shuttle goes into the satchel.
The cloth beam

The warp sags between the beams. On the right side of the loom, at the end of the lower front roller, is an iron ratchet wheel with a handle. Its pawl is lifted onto a peg above it.

  1. Tap the pawl. It drops onto the ratchet wheel.
  2. Turn the handle, or tap it for a quarter turn at a time. The pawl clicks over the teeth, the warp straightens, and the brake lever at the back right lifts its lead weight.
  3. Stop when the lever stands level at the white mark on the stake behind it. The handle goes no further.

Without the pawl, the roller runs back as soon as the handle is let go.

The broken end

This shows once the warp is tight. One band of the warp stays slack.

  1. Go round to the back of the loom. Behind the shafts, the broken end's tail hangs down inside the loom.
  2. Tap the tail. It lifts over the back beam and hangs down behind it.
  3. Tap the lead weight on the S-hook that hangs on a nail in the left back post. It hooks onto the tail and pulls the end tight.
The tie-up

This needs the wound shuttle, the tight warp and the mended end.

The draft card shows three things. The top grid is the threading: each of the eight columns is one band of the warp, and its black square shows which of the four shafts it runs through, shaft 1 at the bottom. The large grid is the cloth: eight rows, the first row woven at the bottom. A cream square is a band lying over the weft, and a coloured square is the weft lying over the band. The blank boxes at the right are for the tie-up and the treadling, which you work out.

The rules:

  • Each treadle has an oak post at its front end with four holes, numbered 1 to 4 from the bottom. A tap on a hole puts a brass peg in it or takes it out. A peg in hole 2 of a treadle ties shaft 2 to that treadle.
  • A tap on the numbered plaque on top of a treadle's post presses the treadle down, and every shaft pegged to it rises with its bands of warp. Two treadles can be down at once, and then the shafts of both rise. A tap on a third treadle buzzes. A tap on a treadle that is down lets it up.
  • A band lies over the weft, cream in the cloth, when its shaft is raised.
  • A shed needs at least one shaft up and one down. Without one, the shuttle stops at the first threads.

A method that weaves any draft:

  1. For each row of the cloth, read off the shafts that must rise: the shafts of the columns that are cream in that row, from the threading.
  2. Write down the different sets of shafts. There are five or more.
  3. Choose four sets, one per treadle, so that every set you wrote down is one treadle's set or the two sets of two treadles together. Start with the sets that are not the joint of two others, and try the largest sets as joints of two smaller ones.
  4. Peg each treadle's post with its set.
  5. Tap the empty shuttle box at the left end of the race on the beater with the wound shuttle.
  6. For the bottom row of the cloth, press its treadle, or its two treadles, by their plaques, and tap the shuttle. The shuttle flies through the shed, the beater beats the pick into the cloth and the treadles rise.
  7. Weave each row upwards in the same way.

The cloth on the loom shows each pick at the reed as soon as it is beaten, the newest at the back. Compare it with the card. A tap on the newest pick pulls it out again. When the eight picks match the card, the workshop goes dark round the lit lamp, the loom weaves on by itself and lets a length of the cloth down over its front.