The ship in a bottle
Level 8
This walkthrough shows once you unlock the level.
A long wooden cabinet stands on a sea chart. A glass bottle lies on the cabinet top in two wooden saddles with brass straps, its neck to the right. The lower part of the bottle holds a dark blue-green resin sea. In front of the bottle, a clipper with a wooden hull stands on a wooden cradle with her bow to the right. A wooden sail chest lies along the front edge of the cabinet top. A brass cork press stands on the cabinet top behind the bottle's neck. The plan of a ship's hold is on an enamel plate on the left half of the cabinet's front. A wooden board on two brass rails is on the cabinet's right end, under the neck. Two drawers stand side by side in the cabinet's left end.
Tap a part to bring the camera to it, then tap the part again to work it. Drag to turn the view round the cabinet. The camera does not move by itself after a step is done. Work through the sections in the order below. You can push the pigs onto the green rings of the hold plan and take the cork from the drawer at any time before they are needed. Four parts move but lead nowhere, and you can ignore them:
- The base end of the bottle, on the left. A tap rolls the bottle in its saddles and it rocks back to rest.
- The small lantern on a brass post at the clipper's stern. It glows dimly from the start and a little brighter with each solved section. A tap lights it in full or turns it back to its glow.
- The brass dividers on the chart to the front right of the cabinet. A tap walks them one step across the chart.
- The left-hand drawer in the cabinet's left end. It slides out with a leather sailmaker's palm and a ball of twine, and slides back.
The clipper
The clipper has three masts. The foremast is nearest the bow, on the right. The mainmast is in the middle and is the tallest. The mizzen mast is nearest the stern, on the left. The lowest yard on each mast has a different length. The mainmast's lowest yard is the longest, the foremast's is shorter, and the mizzen mast's is the shortest. The three suits of sails in the chest have the same three widths. Their order in the chest changes each game.
- Tap the sail chest. Its lid swings forward with a click and hangs down over the front edge of the cabinet with a knock. Three bundles of pale sailcloth lie inside, each tied with two leather bands.
- Compare the widths of the three bundles. The widest goes on the mainmast. The middle one goes on the foremast. The narrowest goes on the mizzen mast. For example, if the chest holds, from left to right, the middle width, the widest and the narrowest, the left bundle goes on the foremast, the middle bundle on the mainmast and the right bundle on the mizzen mast.
- Tap a bundle. It lifts out of its slot with a tick. Tap it again to put it back, or tap another bundle to lift that one instead.
- Tap the mast that the lifted bundle belongs on. The bundle moves to the mast's lowest yard. If it fits, it disappears with a hiss, rolls of furled sail appear along the yards, and the yards swing up to lie along the mast with a knock. If it does not fit, a buzz sounds and the bundle goes back into the chest.
- Repeat steps 3 and 4 for the other two bundles.
- Tap the brass cleat on the wooden post at the right end of the cradle. It turns with a clank, the threads go slack and the five spars fold down one after another, each with a knock.
- Tap the hull. The clipper lifts off the cradle, swings round past the cabinet's right end and is pushed stern first through the neck with a scraping sound. She settles on the resin sea with a knock. Her five coloured threads now run out of the bottle's mouth and down to the board on the cabinet's right end.
The sails can be put on only while the spars stand. If you tapped the cleat before all three bundles were on, tap it again to stand the spars, then finish steps 3 to 5. If the clipper knocks at the mouth and comes back to the cradle, one of these is not done: a bundle is still in the chest, a spar still stands, or the cork in the press rests on the mouth. To clear the mouth, tap the handwheel on top of the press's post to raise the cork.
The ballast
The hold plan is on the left half of the cabinet's front. The bow is at the top and the stern at the bottom. The left side of the plan is the port side and the right side is the starboard side. The plan shows a plank floor, a darker grating round the edge, three brass mast steps on the centre line, two or three wooden casks with brass hoops, three dark iron pigs and a small brass stevedore. The stevedore starts at the ladder in the middle of the bottom row. The pigs start on the port side, so the clinometer under the plan shows a lean to port. Three green rings mark the cells where the pigs must go. Their places change each game.
Under the plan, from left to right, are a brass button with a curved arrow, a lamp, a clinometer with a hanging needle, and a red button. The needle swings to the side the clipper leans to. When the clipper is in the bottle, she leans the same way.
The plan follows these moves:
- Tap a cell next to the stevedore, above, below, left or right of him, to step there.
- If a pig is in that cell, the stevedore pushes it one cell further on and steps into its old cell.
- Tap a cell further away to walk the stevedore there round the pigs. He does not push anything on the way.
- A pig cannot be pushed into a cask, a mast step or another pig, or onto the grating. The stevedore can walk on the grating.
- A pig cannot be pulled.
- A move that is not allowed makes a buzz and nothing moves.
- The brass button takes back the last move. The red button puts the pigs and the stevedore back where they started.
To push a pig in a direction, walk the stevedore to the cell on the opposite side of the pig, then tap the pig. Use this method:
- Pick a pig and the green ring it will go to. Choose pairs so that the routes of the pigs do not cross.
- Push the pig along its row until it is in the ring's column, or along its column until it is in the ring's row.
- Walk the stevedore round to the other side and push the pig the rest of the way.
- A pig crosses the centre line only through the gaps between the mast steps.
- Do not push a pig into a cell that has a cask, a mast step or another pig on two sides that meet at a corner, such as above and to the left. A pig there cannot be pushed out again unless a pig next to it moves.
- When a pig cannot reach its ring, tap the brass button until it can, or tap the red button and start again.
When all three pigs are on the green rings, the lamp under the plan lights green, the needle hangs straight down, and the clipper floats upright once she is in the bottle.
The fairleads
This part opens when the clipper is in the bottle. Turn the view to the cabinet's right end and tap the board. A brass neck plate with five holes is at the top. A thread comes down through each hole and ends in a small wooden toggle with a coloured bead. Below that, the board carries a brass drawing of the clipper with her bow to the right, and a row of five brass belaying pins. A dashed line runs down from each spar in the drawing to the pin under it.
Each thread raises one spar, and its colour shows which:
- Red is the bowsprit. Its pin is on the far right.
- Blue is the foremast. Its pin is second from the right.
- Green is the mainmast. Its pin is in the middle.
- Yellow is the mizzen mast. Its pin is second from the left.
- Cream is the ensign staff. Its pin is on the far left.
The knob on each spar head in the bottle has the same colour as its thread. The order of the toggles under the neck plate changes each game. No toggle hangs over its own pin.
- Tap a toggle. It lifts with a tick, and its spar in the bottle lifts halfway and falls back with a knock. Tap the same toggle again to let it hang.
- Read the colour of the toggle's bead. For example, a green bead belongs on the middle pin.
- Tap the pin for that colour. The toggle moves onto the pin with a knock.
- Repeat for the other four toggles.
If you tap a pin that already holds a thread, the lifted thread goes on that pin and the other thread comes off, lifted. Then tap the correct pin for that thread. Tapping a pin with nothing lifted takes its thread off and lifts it. The red button in the lower left corner of the board takes every thread off.
When every thread is on its own pin, the lamp above the left end of the neck plate lights green and the threads in the bottle run straight from the spar heads to the mouth. The board then slides out on its rails, turns over and slides back.
The haul
The back of the board now faces you. Five belaying levers stand on a brass rail. From left to right, their ball tops are red for the bowsprit, blue for the foremast, green for the mainmast, yellow for the mizzen mast and cream for the ensign staff. Above each lever is a lamp, and above the lamps is a row of brass pointers. All five spars lie flat. Each lever points down and each pointer lies flat to the right.
Tap a lever to stand its spar up or lay it flat. The lever swings over, its pointer rises or falls, and its spar in the bottle stands up or lies down. A spar moves only while the next spar to its right on the rail stands and every spar further right lies flat. The cream lever for the ensign staff always moves. A green lamp shows each lever that can move now. Tapping a lever that cannot move makes a buzz, and a message names the spar that is in the way.
- Tap the cream lever on the far right.
- Tap the one other lever whose lamp is green.
- Tap the cream lever again.
- Keep going: tap the other green-lamp lever, then the cream lever, and so on. Never tap the same lever twice in a row.
This takes 21 taps. Numbering the levers 1 to 5 from the left, the full order is 5, 4, 5, 3, 5, 4, 5, 2, 5, 4, 5, 3, 5, 4, 5, 1, 5, 4, 5, 3, 5. A second tap on the same lever undoes its move. If you do that by mistake, tap the same lever once more and carry on.
The sails are released only when all five spars stand and the hold plan's pigs are on the green rings. If all five spars stand and nothing more happens, push the pigs on the hold plan onto the green rings. When both are done, the lamps go dark, the yards swing square across the hull, the sails drop and fill with a hiss, and the clipper heels over to port.
The trim
Turn back to the hold plan on the cabinet's front. When the clipper heeled, the green rings shrank away and every pig slid to the port side, on the left, with a rumble. The stevedore is back at the ladder. Three blue rings now mark new cells on the starboard side, on the right. Their places change each game. The clinometer's needle and the clipper both lean to port.
The moves are the same as on the green rings, with one change. The floor now slopes down to port. A pig pushed to the left slides on until a cask, a mast step, another pig or the grating stops it. A push to the right, up or down still moves a pig one cell. The red button now puts the pigs back where they were after they slid.
- Pick a pig and the blue ring it will go to.
- Move the pig with pushes to the right, up and down. These move one cell at a time.
- Push a pig to the left only when it must go to the left and a cask, a mast step, another pig or the grating fills the next cell to the left of where it must stop.
- If a pig slides too far or gets stuck, tap the brass button to take the push back.
When all three pigs are on the blue rings, the lamp under the plan lights green, the needle hangs straight down and the clipper sails upright.
The locker
Turn the view to the cabinet's left end and tap the drawers. Two drawers with brass knobs stand side by side. The cork is in the right-hand drawer, the one nearer the cabinet's front.
- Tap the right-hand drawer. It slides out with a scrape and stops with a knock. A cork lies on a bed of wood shavings inside.
- Tap the cork. It flies into the satchel at the top left of the view, and a message reads "Found · Cork".
The cork press
The press is on the cabinet top behind the bottle's neck. A brass post carries a beam out over the bottle's mouth. Under the beam, an empty brass ring hangs on a steel rod. This ring is the jaw. A brass handwheel with a wooden handle sits on top of the post. You need the cork from the drawer in the cabinet's left end.
- Tap the jaw. The cork from the satchel appears in the ring with a click. Without the cork, a buzz sounds and a message says the jaw holds a cork.
- Tap the handwheel. The wheel turns and the jaw runs down the rod until the cork rests on the bottle's mouth.
Each further tap on the handwheel runs the cork up or down again. An empty jaw runs down to the mouth and straight back up.
Do not lower the cork before the clipper is in the bottle, because she cannot pass a cork on the mouth. If the cork reaches the mouth before the hold plan's blue rings are filled, it waits there, and the press finishes as soon as the pigs are on the blue rings. When the cork rests on the mouth and the clipper sails upright, the press cuts the threads, drives the cork home and seals the bottle with red wax. The workshop goes dark, the stern lantern lights the bottle and the clipper rides the sea under full sail.