The airship

Level 4

This walkthrough shows once you unlock the level.

An airship stands on two wooden trestles on a green leather table. Its nose is moored to an iron lattice mast at the bow end. The mast stands on an iron winch house. A wooden gondola hangs under the pale linen envelope, and two engine pods with wooden propellers hang from its sides. There are five panels to work. On the side of the gondola that faces you at the start, the gas manifold is at the tail end and the helm is at the bow end. On the far side of the gondola, the magneto is at the tail end and the chart table is at the bow end. The mooring board is on the near face of the winch house under the mast. Drag across the view to turn round the airship. Tap a panel to fly in to it. Tap the step-back button at the bottom left to fly out again.

Every panel can be worked from the start. Work them in the order of this page: the gas manifold, the magneto, the chart table, the mooring board, then the helm. The magneto needs the gas. The helm needs the gas, the engines, the clear mooring lines and the weather card from the chart table. After each panel is finished, the camera stays where it is. The envelope, the propellers, the mast and the rest of the airship have no controls.

The gas manifold

The gas manifold is the panel on the near side of the gondola, at the tail end. A copper retort on a brass burner ring stands at the left of the panel. This is the generator. A copper pipe runs from it into the left end of one row of the grid. Three copper pipes rise from the top edge of the grid. Each one has a brass valve and a green lamp above it. These are the outlets. The round gauge in the generator's column is the lift gauge.

The grid holds 20 iron pipe tiles in four rows of five. There are four shapes:

  • An elbow bends through a right angle.
  • A straight pipe has a coupling sleeve in its middle.
  • A tee has three ends and a cross has four ends. Both have a round body with a hex nut.
  • A cap tile has one end, closed by a domed cap.

Tap a tile to turn it a quarter turn clockwise. It ticks as it turns. Four taps bring a tile back to where it started. Every tile that gas reaches from the generator turns copper. The green lamp over an outlet lights while gas reaches it.

The rule is that every open pipe end meets an open pipe end on the next tile. The only ends that may point off the grid are the one that points left into the generator pipe and the three that point up into the outlet pipes. Every tile must carry gas. The manifold shows no warning for a wrong tile. A tile that stays iron, an outlet lamp that stays dark or a pipe end that points at a closed side shows where the fault is.

  1. Turn the left tile in the generator's row until one of its ends points left into the generator pipe.
  2. Turn each top-row tile under an outlet pipe until one of its ends points up into that pipe.
  3. Turn the other tiles on the edges so that no end points off the grid. A straight pipe on an edge lies along the edge. An elbow in a corner with no pipe beside it has only one position. A tee on an edge has its closed side towards the edge.
  4. Work inward from the placed tiles. Each placed tile tells its neighbour whether the side between them is open or closed. Turn the neighbour until its ends match.
  5. Do not point two cap tiles at each other. Gas cannot reach a pair of joined caps.
  6. Do not close the pipes into a ring. The finished manifold has no ring.
  7. Check that every tile is copper and all three outlet lamps are lit.

When the last tile is right, gas hisses out of the three outlets in white puffs. The lift gauge needle climbs and the envelope swells out taut.

The magneto

The magneto is the panel on the far side of the gondola, at the tail end. Four brass drums run across the top behind a brass window. Each drum shows one sign in its window. Under the drums is a row of four green lamps, and under those a row of four amber lamps. A paper tape between two brass rollers is at the lower left. A test lever with a red knob is at the lower right, in front of a brass quadrant. An orange lamp with a flame picture beside it is above the lever. This is the burner lamp.

Each drum carries six signs: the sun, the moon, the star, the gear, the drop and the diamond. Tap a drum to turn it to the next sign, in that order. Six taps bring it back. Every drum starts on the sun. Turning a drum puts out the green and amber lamps.

The magneto has a code of four different signs, one per drum. The code is different in every game. Tap the lever to test the drums. The lever throws down with a clank and springs back. Then the lamps light:

  • One green lamp for each drum that shows the right sign.
  • One amber lamp for each sign that is in the code but on the wrong drum.

The lamps count. They do not show which drum is right. The tape prints a row for each test, with the newest test at the top. A row shows the four signs, a filled dot for each green lamp and a ring for each amber lamp. The tape shows the last eight tests. There is no limit on the number of tests.

This method finds the code in any game:

  1. Find out which signs are in the code. Tap the lever with all four drums on the sun. One green lamp means the sun is in the code. No lamp means it is not.
  2. Tap each drum once, so all four show the moon, and tap the lever. Go on through the star, the gear, the drop and the diamond in the same way.
  3. Stop when two signs have lit no lamp. The other four signs are the code. If the first four signs all light a green lamp, the drop and the diamond are not in the code.
  4. Pick one sign that lit no lamp. This is the blank.
  5. Set drums 2, 3 and 4, counted from the left, to the blank. Set drum 1 to one of the code signs. Tap the lever.
  6. A green lamp means drum 1 takes that sign. Leave it there. An amber lamp means that sign belongs on another drum. Try the next code sign on drum 1.
  7. Move on to drum 2 and try each code sign that is not yet placed, with the blank on the drums to its right. A test that lights one more green lamp than the drums already found means the drum you are trying is right.
  8. Do the same for drum 3. The last code sign goes on drum 4.
  9. Tap the lever with all four drums set. Four green lamps light.

For example, the sun and the star light one green lamp, the moon lights none, the gear lights one green lamp and the drop lights none. The code is the sun, the star, the gear and the diamond. The moon is the blank. A test of star, moon, moon, moon lights one amber lamp, so the star is not on drum 1. A test of gear, moon, moon, moon lights one green lamp, so drum 1 is the gear.

The engines start only once gas reaches the burner. Finish the gas manifold first, and the burner lamp lights. If you test the right code before then, the magneto buzzes and a message says the timing is right but the burner has no gas. Leave the drums as they are. The engines start when the gas manifold is finished. If you turn a drum after that test, set the code again and tap the lever after the burner lamp is lit.

When the engines start, the magneto gives a thump, the engines rumble and steam bursts from the two engine pods. The propellers start to turn and the engine pods puff exhaust.

The chart table

The chart table is the panel on the far side of the gondola, at the bow end. It holds a cream weather card with a grid of six rows of six cells, in an iron holder. The numbers above the card belong to the columns, read from top to bottom. The numbers to the left of the card belong to the rows, read from left to right. A strip below the card holds a green lamp at the left, a picture of a hole turning into a storm cloud in the middle, and a red button on a brass boss at the right.

Tap a cell to punch a hole in it. It clanks and a ragged hole appears. Tap a punched cell again to patch it. Tap the red button to patch every hole.

The rule is that the numbers beside a row or a column give the lengths of the runs of punched holes in that line, in order. Two runs have at least one unpunched cell between them. Every line has at least one run. The numbers are different in every game. The card shows nothing while a line is wrong. The green lamp lights only when every row and every column matches its numbers. Each card has exactly one answer.

This method fills any card:

  1. For each line, add its numbers and add one for each gap between runs. If the total is six, the line has one layout. Punch it.
  2. If the total is less than six, the difference is the slack. A run longer than the slack covers some cells wherever it sits. Push all runs as far left as they go, then as far right. Punch the cells that the same run covers in both layouts.
  3. Use the cells you know in the crossing lines. A cell that no layout of a line's runs can cover stays unpunched. A run that already touches a known hole and the edge or a gap can be finished.
  4. Repeat steps 2 and 3 across all rows and columns until no line gives a new cell.
  5. If no line gives a new cell, punch a cell that one line allows and carry on. If a line then cannot fit its numbers, patch that cell. It stays unpunched in the answer.

For example, a row with the number 4 has a slack of 2. The run covers the third and fourth cells in every layout, so punch those two. A row with the numbers 3 and 2 adds up to six with its gap. Punch the first three cells and the last two cells.

When the card is right, the green lamp lights, the card lifts out of its holder and flies into the satchel at the top left of the view. A message names the weather card.

The mooring board

The mooring board is the panel on the near face of the iron winch house under the mast. Eight brass horn cleats stand on it. Hemp ropes run between the cleats. The ropes and their cleats are different in every game.

Drag a cleat to move it. Its ropes stretch with it. A cleat stays inside the area of the board. A rope shows red while it crosses another rope or runs over a cleat that it is not tied to. A rope shows pale hemp when it is clear. To undo a move, drag the cleat back.

The rule is that no two ropes cross and no rope runs over a cleat. The board checks the ropes each time you let go of a cleat.

The ropes were tied with the cleats in two columns of four. In that layout most ropes join cleats that stand next to each other, in the same column, across, or diagonally across.

  1. Pick a cleat with few ropes. Drag it to the top left of the board.
  2. Drag the cleats tied to it next to it: one to its right and one below it.
  3. Work down the board. Place each next cleat beside the placed cleats it is tied to, so its ropes run to its neighbours.
  4. Where a rope still shows red, drag one of its cleats to the other side of the rope it crosses, or a little away from the cleat it runs over.

When the last rope comes clear, the board hisses and all eight cleats rise a little.

The helm

The helm is the panel on the near side of the gondola, at the bow end. A night blue plotting table with a brass grid of six by six squares is at the top. A small pale ship with brass fins stands on its start square. A small brass lattice mast with a green glow stands on the port square. A dotted line joins the start and the port in a straight line. The dotted line is not the course. Four arrow keys with ivory triangles stand round a red button at the lower left. A brass card slot is at the lower right. Below the slot are three green lamps:

  • The left lamp, with an envelope picture, lights when the gas manifold is finished.
  • The middle lamp, with a propeller picture, lights when the engines start at the magneto.
  • The right lamp, with an anchor picture, lights when the mooring board is clear.

The helm needs the weather card from the chart table. Without it, a tap on the slot or an arrow clanks and a message says the plotting table needs the weather card.

  1. Tap the brass slot, or any arrow key, with the weather card in the satchel. The card drops into the slot with a click. Pale storm clouds with lightning bolts grow on the plotting table, one on each square that you punched on the card.
  2. Tap an arrow key to send the ship up, right, down or left on the table. The ship flies in a straight line until the next square is a storm or the edge of the table. If it cannot move, it turns to face that way and thuds.
  3. Tap the red button to send the ship back to its start square.

The storms and the port are different in every game. The shortest course takes four to eight moves. Work backwards from the port to find it:

  1. Look at the four squares next to the port. The ship can stop on the port only against a storm or the edge of the table on its far side.
  2. For each such side, the ship arrives moving towards it. Every square on the opposite side of the port, in the same row or column, up to the first storm, reaches the port in one move.
  3. Find the squares from which one move stops on one of those squares. The ship stops on a square only when the next square in its direction is a storm or the edge.
  4. Repeat until the start square is in your list. Then tap the moves from the start in order.

For example, the port has a storm on the square to its right. The last move is right, from any square to the left of the port in its row with no storm in between. If the ship can stop on one of those squares with a move down, that move comes before it.

When the ship stops on the port, a chime sounds. If a lamp is still dark, a message says the ship sails once all three lamps are lit. Leave the ship on the port and finish the panel that lights that lamp. The helm finishes as soon as the last lamp lights.

When the ship stops on the port with all three lamps lit, the handling lines drop, the propellers run up, the workshop goes dark, the portholes blaze and the airship backs off the mast and climbs.